Table of Contents
Advertisement
Flow Control with Timeout: The scanner asserts RTS when it has data to send and
waits for a delay (see
host. If the delay time expires and CTS is not asserted, the device transmit buffer is
cleared and scanning may resume. Default = RTS/CTS Off.
RS232 Timeout
When using Flow Control with Timeout, you must program the length of the delay
you want to wait for CTS from the host. Set the length (in milliseconds) for a
timeout by scanning the barcode below, then setting the timeout (from 1-5100
milliseconds) by scanning digits from the
Save.
XON/XOFF
Standard ASCII control characters can be used to tell the scanner to start sending
data (XON/XOFF On) or to stop sending data (XON/XOFF Off). When the host
sends the XOFF character (DC3, hex 13) to the scanner, data transmission stops.
To resume transmission, the host sends the XON character (DC1, hex 11). Data
transmission continues where it left off when XOFF was sent. Default = XON/XOFF
Off.
34
RS232 Timeout
Flow Control, No Timeout
Flow Control with Timeout
XON/XOFF On
on page 34) for CTS to be asserted by the
Programming
RS232 Timeout
Two-Direction Flow Control
* RTS/CTS Off
Chart, then scanning
Voyager XP User Guide
- Quick Links:
- Connect with Usb
Hide quick links:
Advertisement
Table of Contents
