Sony HT-SF2000 Operating Instructions Manual page 29
Hide thumbs
Also See for HT-SF2000:
- Operating instructions manual (68 pages) ,
- Quick setup manual (2 pages) ,
- Speaker stand installation manual (2 pages)
Table of Contents
Advertisement
Warning code Explanation
WARN 43
The distance and position of a sub
woofer calmot be detected. This
may be caused by noise. Try to
perform the Auto Calibration in a
quiet environment.
NO WARN
There is no warning information.
When you select
"PHASE"
You can check the phase of each speaker
(ill
phase/out
of phase).
Press #/# repeatedly to select a
speaker, then press k'_ to return to
step 2 in "Confirming/saving
the
measurement
results".
Display
II II,_ IN
mm ,_ OUT
Explanation
The speaker is in phase.
The speaker is out of phase. The
"+" and
terminals of the
speaker may be connected the
other way m'ound. However,
depending on the speakers,
,,mm,I
OUT" appears on the
display even though the speakers
are cmmected properly. This is
because of the speakers'
specifications.
In this case. you
can continue to use the receiver.
" ll
represent a speaker channel
FL
Front left
FR
Front right
C
(enter
SL
Surround left
SR
Sm'round right
SW
Sub woofer
Tip
Depending on the position of the sub woofer, the
measurement results for polarity may valy.
However, there will be no problems even if you
continue to use the receiver with that value.
You can use the A. CAL menu
to make
if)
settings
for the Auto Calibration
function
to
suit your preference.
"
Select "8-A. CAL" in the amplifier
menus. For
details
on adjusting
the parameters,
see
"
"Navigating
through
menus"
(page 34) and
"Overview
of the menus"
(page 35).
• AUTO CAL (Auto Calibration on/
off)
• A.CAL
NO
The Auto Calibration
function
is turned off.
• A.CAL
YES
The Auto Calibration
function
start.
• CAL LOAD (Calibration load)*
• LOAD
YES
Select this when you want to load the saved
Auto Calibration
result.
• LOAD
NO
Select this when you do not want to load the
saved Auto Calibration
result.
You can select this parameter only when you have
performed the Auto ( alibration and saved the
settings.
After you have finished
Disconnect
the optimizer
microphone
from the
receiver.
29_e
Advertisement
Chapters
Table of Contents
