Table of Contents
Advertisement
Next steps
1.
Replace the BOSS-N1 module
Installing the BOSS-N1 module
The procedure to install is the BOSS-N1 module with 4 x 2.5-inch rear drive module is similar.
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. If installed,
remove the BOSS module
Steps
1. Connect the BOSS-N1 power and signal cables to the connectors on the BOSS-N1 module.
Figure 147. Connecting the BOSS-N1 power and signal cables to the BOSS-N1 module
2. Insert the BOSS-N1 module and push the module horizontally towards the rear of the system until firmly seated.
3. Using the Phillips #1 screwdriver, secure the BOSS-N1 module with the M3 x 0.5 x 4.5 mm screws.
4. Connect the BOSS-N1 power and signal cable to the connectors on the system board.
174
Installing and removing system components
or
Install the BOSS-N1 module
Safety
instructions.
Before working inside your
blank.
blank.
system.
Advertisement
Table of Contents
