Table of Contents
Advertisement
8.2.2
Characteristics of Network Functions
This section discusses the following network function characteristics:
LAN Interface
The connector for 10Base-T/100Base-TX is equipped with the controller. 10Base-
T/100Base-TX is selected automatically.
Network Parameter
The WMS100 has the following network parameters; they can be set or changed by the
Web browser or the Storage Navigator Modular, concerning only port 1 (for user
management) of each controller.
Table 8.3
Network Parameters
Network Parameter
IP Address
Subnet Mask
Default Gateway
DHCP
(see Note 2)
Note 1: Manage the IP Address after the IP Address is changed from the IP Address of factory
setting.
Note 2: When the DHCP mode is validated, the IP Address is acquired from the DHCP server.
If the DHCP server is not started up, or if the DHCP function has been wrongly set, the
acquisition of the IP Address will fail, and the IP Address of the subsystem will remain
0.0.0.0. (This is a state in which Storage Navigator Modular or the Web cannot be used via a
LAN.) You can acquire the IP Address by starting up the DHCP server or by setting the DHCP
function correctly, when necessary.
Description
The IP Address is
changed/set up.
The Subnet Mask is
changed/set up.
The Default Gateway is
changed/set up.
Enable/Disable of the DHCP
function is set up.
Acer | HDS WMS100™ User and Reference Guide
Factory Setting Value (see Note 1)
Controller 0
For User-managed Port
192.168.0.16
(see Note 1)
255.255.255.0
0.0.0.0
Off
Controller 1
For User-managed Port
192.168.0.17
(see Note 1)
255.255.255.0
0.0.0.0
Off
181
Advertisement
Table of Contents
Troubleshooting
