Table of Contents
Advertisement
4.3.2.2
When the FC Interface Board is Added
The available Fibre Channel connection configuration varies, depending on the topology
setting of the WMS100 and the destination of the Fibre Channel cable connection. The
following table shows available Fibre Channel connection of each topology setting and
connection method.
Table 4.2
Available Host Connectors of Each Topology Setting and Connection/Method
No.
WMS100 Topologies
1
Loop
2
Point-to-Point
Note:
TagmaStore USP is an abbreviation for Universal Storage Platform, and it is a higher-level
model in the TagmaStore series.
When connecting the WMS100 directly to the host, the Loop topology is set to the port.
The port that the Point-to-Point topology has been set to cannot be connected directly
to the host, TagmaStore USP or 9900V.
When connecting the WMS100 to the Switch, the Point-to-Point topology is set to the port.
The port that the Loop topology has been set to cannot be connected to the Switch.
56
Chapter 4 Subsystem Architecture and Components
WMS100 Transfer
Direct Connection to
Rate
the Host
Auto/1 Gbps/2
Host Connector 0 and
Gbps/ 4Gbps
1
Auto/1 Gbps/2
Not Supported
Gbps/ 4Gbps
Switch Connection
Direct Connection
to the TagmaStore
USP (Note)Direct
Connection to the
9900V
Not Supported
Host Connector 0
and 1
Host Connector 0 and
Not Supported
1
Advertisement
Table of Contents
Troubleshooting
