Table of Contents
Advertisement
Appendix B System Parameter Settings List
The following table lists the parameter settings using the Storage Navigator Modular.
System Parameter
1
System Startup Attribute
2
Drive Detach mode enable
3
Turbo LU Warning
4
Operation if the Processor failures Occurs
5
ROM Microprogram Version
6
RAM Microprogram Version
7
Write & Verify Executing Mode
8
DHCP (see Note 2)
9
Maintenance Port IP Address
10
IP Address
11
Subnet Mask
12
Default Gateway
Host Group
1
LU Mapping Mode
Note 1: When the WMS100 is connected, the logical unit which is not wanted to be accessed
by the port must be masked by means of the LU mapping mode.
Note 2: When the DHCP mode is validated, the IP Address is acquired from the DHCP server.
If the DHCP server is not started up or the DHCP function has been wrongly set, the
acquisition of the IP Address will fail and the IP Address of the subsystem will remain
"0.0.0.0". (This is a state in which Storage Navigator Modular or the Web cannot be used via
a LAN.)
You can acquire the IP Address by starting up the DHCP server or by setting the DHCP
function correctly when necessary.
Depends on System Configuration.
Disable (Standard setting).
Disable (Standard setting).
Reset a Fault (Standard setting).
No change is needed.
No change is needed.
On (Standard setting).
OFF (Standard setting).
To be set according to the network setting.
To be set according to the network setting.
To be set according to the network setting.
To be set according to the network setting.
Depends on System Configuration (see Note 1)
Acer | HDS WMS100™ User and Reference Guide
237
Advertisement
Table of Contents
Troubleshooting
