Siemens REV17 Series Installation Instructions Manual page 7
Hide thumbs
Also See for REV17 Series:
- Operating instructions (2 pages) ,
- Instructions manual (13 pages)
Advertisement
Code list
Function block
Basic settings
LCD settings
Clock settings
Note 1:
If the radio clock is not active or not present, this setting has no impact.
With the radio clock active, the time signal received from Frankfurt is shifted by the value set under code 30 (time zone).
Note 2:
If the radio clock is not active or not present, the time change always takes place at 02:00 on the Sunday before the set date.
With the radio clock active, the time change is shifted by the value set under code 30 (time zone).
Note 3:
If the radio clock is not active or not present, the time change always takes place at 03:00 on the Sunday before the set date.
With the radio clock active, the time change is shifted by the value set under code 30 (time zone).
3
Function check
g) Check the display. If there is no display, check the batteries
h) "Continuously Comfort mode"
displayed
i)
Set the temperature setpoint to a level above the displayed
room temperature (see operating instructions)
j)
The relay and thus the actuating device must respond within 1
minute. Symbol
▲
appears on the display. If not:
Check actuating device and wiring
•
The room temperature is possibly higher than the adjusted
•
temperature setpoint
k) Set temperature setpoint of "Continuously Comfort mode"
the required level
l)
Select the required operating mode
CE1G2203xx
Code
Name
00
Language
01
Sensor calibration
02
Switching differential 2-point
10
Illumination time
11
Background brightness
12
Contrast
Time zone
Deviation from time signal
30
received from Frankfurt
(Central European Time CET)
(refer to Note 1)
Start of summer time
31
(refer to Note 2)
End of summer time
32
(refer to Note 3)
, read the temperature
Factory setting
English
off
0.5° C
10 seconds
0
0
0 hours
March 31 (31-03)
October 31 (31-10)
4
Reset
User-defined settings:
Press simultaneously
All temperature and time settings of the slider positions are reset to
their default values (refer to section "Factory settings" in the
operating instructions). The settings made on the expert level will
remain unchanged.
The clock starts at 12:00, the date on 01-01-08
(01 - January - 2008). During the reset time, all sectors of the
display are illuminated and can thus be checked.
All user-defined settings plus those made on the expert level:
Press simultaneously the DIP switch reset button,
for 5 seconds:
After this reset, all factory settings will be reloaded. This applies
to both the slider settings and the settings made on the expert
to
level.
Notes
The controller is classified as a device of software class A and
•
designed for use in environments with normal degree of
pollution
13.12.2007
Your setting
,
and
for 3 seconds:
and
7/25
Advertisement
