Debug Platform Udld - Cisco Catalyst 3560X-24P Command Reference Manual

Cisco ios release 12.2(55)se

Hide thumbs Also See for Catalyst 3560X-24P:

Table of Contents

Catalyst 3750-X and 3560-X Switch Debug Commands

debug platform udld

Use the debug platform udld privileged EXEC command to enable debugging of the

platform-dependent UniDirectional Link Detection (UDLD) software. Use the no form of this command

to disable debugging.

Syntax Description

rpc {events | messages}

Debugging is disabled.

Command Modes

Privileged EXEC

Command History

Usage Guidelines

The undebug platform udld command is the same as the no debug platform udld command.

When you enable debugging on a switch stack, it is enabled only on the stack master. To enable

debugging on a stack member, you can start a session from the stack master by using the session

switch-number privileged EXEC command. Then enter the debug command at the command-line

prompt of the stack member. You also can use the remote command stack-member-number LINE

privileged EXEC command on the stack master switch to enable debugging on a member switch without

first starting a session.

Related Commands

show debugging

debug platform udld [all | error | rpc {events | messages}]

no debug platform udld [all | error | rpc {events | messages}]

(Optional) Display all UDLD debug messages.

(Optional) Display error condition debug messages.

(Optional) Display UDLD remote procedure call (RPC) debug messages.

The keywords have these meanings:

Modification

This command was introduced.

Displays information about the types of debugging that are enabled.

events—Display UDLD RPC events.

messages—Display UDLD RPC messages.

Catalyst 3750-X and 3560-X Switch Command Reference

debug platform udld