Table of Contents
Advertisement
16- and 36-Port Ethernet Switch Module for Cisco 2600 Series, Cisco 3600 Series, and Cisco 3700 Series
dot1x default
To reset the global 802.1x parameters to their default values, use the dot1x default command in global
configuration mode.
Syntax Description
This command has no arguments or keywords.
Defaults
This command has no default setting.
Command Modes
Global configuration
Command History
Release
12.1(6)EA2
12.2(15)ZJ
Examples
The following example shows how to reset the global 802.1x parameters:
Switch(config)# dot1x default
You can verify your settings by entering the show dot1x privileged EXEC command.
Related Commands
Command
dot1x max-req
dot1x re-authentication
dot1x timeout quiet-period
dot1x timeout re-authperiod
dot1x timeout tx-period
show dot1x
dot1x default
Modification
This command was introduced.
This command was implemented on the following platforms: Cisco 2600
series, Cisco 3600 series, and Cisco 3700 series routers.
Description
Sets the maximum number of times that the switch sends an
EAP-request/identity frame before restarting the authentication
process.
Enables periodic reauthentication of the client.
Sets the number of seconds that the switch remains in the quiet state
following a failed authentication exchange.
Sets the number of seconds between reauthentication attempts.
Sets the number of seconds that the switch waits for a response to
an EAP-request/identity frame from the client before retransmitting
the request.
Displays the 802.1x statistics, administrative status, and operational
status for the switch or for the specified interface.
Cisco IOS Release 12.2(2)XT, 12.2(8)T, and 12.2(15)ZJ
dot1x default
173
Hide quick links:
Advertisement
Chapters
Table of Contents
