Table of Contents
Advertisement
Configuring SMDI Settings on the VG248
Step 4
Forwarding INV Responses to Async 1
Step 1
Step 2
Step 3
Step 4
Identifying the Directory Number for Setting MWI on
Cisco CallManager
Cisco VG248 Analog Phone Gateway Software Configuration Guide
5-26
Chapter 5
Choose one of the following:
•
yes
•
no
Some PBX systems generate an INV response to MWI commands from the voice
mail system if an error occurs.
The VG248 cannot distinguish which extension numbers are connected to the
legacy PBX and which are connected to Cisco CallManager. Therefore, MWI
commands are sent to both systems. If the VG248 is connected to a legacy PBX
and Cisco CallManager (such as in the multiplexing configuration), the PBX is
likely to generate these error responses to commands it receives from the VG248.
From the main menu, choose Configure.
Choose SMDI.
Choose Forward INV responses to Async 1.
Choose one of the following:
yes—errors generated by the PBX are sent to the voice mail system.
•
•
no—default setting
If you have enabled the VG248 to forward MWI commands from the voice mail
system to Cisco CallManager, you must identify the directory number used to set
MWI commands. The value should match the value entered in the
Cisco CallManager MessageWaitingOnDN parameter, which is available by
choosing Service > Service Parameters in Cisco CallManager.
Integrating Cisco CallManager with Voice Mail Systems Using SMDI
OL-1209-02
- Quick Links:
- Accessing Configuration Options
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
