Cisco WS-C3560-48PS-S Hardware Installation Manual page 112
Catalyst 3560 series switch
Hide thumbs
Also See for WS-C3560-48PS-S:
- Product manual (20 pages) ,
- Software configuration manual (892 pages)
Table of Contents
Advertisement
Completing the Setup Program
Enter an enable password, and press Return.
Step 4
Enter enable password: enable_password
Enter a virtual terminal (Telnet) password, and press Return.
Step 5
The password can be from 1 to 25 alphanumeric characters, is case sensitive, allows spaces, but ignores
leading spaces.
Enter virtual terminal password: terminal-password
(Optional) Configure Simple Network Management Protocol (SNMP) by responding to the prompts.
Step 6
You can also configure SNMP later through the CLI, CMS, or Network Assistant interface. To configure
SNMP later, enter no.
Configure SNMP Network Management? [no]: no
Step 7
Enter the interface name (physical interface or VLAN name) of the interface that connects to the
management network, and press Return. For this release, always use vlan1 as that interface.
Enter interface name used to connect to the
management network from the above interface summary: vlan1
Configure the interface by entering the switch IP address and subnet mask and pressing Return. The IP
Step 8
address and subnet masks shown are examples.
Configuring interface vlan1:
Configure IP on this interface? [yes]: yes
IP address for this interface: 10.4.120.106
Subnet mask for this interface [255.0.0.0]: 255.0.0.0
Enter Y to configure the switch as the cluster command switch. Enter N to configure it as a member
Step 9
switch or as a standalone switch.
If you enter N, the switch appears as a candidate switch in the CMS or Network Assistant. You can
configure the switch as a command switch later through the CLI, CMS, or Network Assistant interface.
To configure it later, enter no.
Would you like to enable as a cluster command switch? [yes/no]: no
You have now completed the initial configuration of the switch, and the switch displays its initial
configuration. This is an example of output that appears:
The following configuration command script was created:
hostname switch1
enable secret 5 $1$Ulq8$DlA/OiaEbl90WcBPd9cOn1
enable password enable_password
line vty 0 15
password terminal-password
no snmp-server
!
no ip routing
!
interface Vlan1
no shutdown
ip address 10.4.120.106 255.0.0.0
!
interface FastEthernet1/0/1
!
interface FastEthernet1/0/2
interface FastEthernet1/0/3
!
...<output abbreviated>
!
interface GigabitEthernet2/0/28
Catalyst 3560 Switch Hardware Installation Guide
D-4
Appendix D
Configuring the Switch with the CLI-Based Setup Program
OL-6337-07
Hide quick links:
Advertisement
Table of Contents
