Cisco WS-C3560-48PS-S Hardware Installation Manual page 65
Catalyst 3560 series switch
Hide thumbs
Also See for WS-C3560-48PS-S:
- Product manual (20 pages) ,
- Software configuration manual (892 pages)
Table of Contents
Advertisement
Chapter 3
Switch Installation (8- and 12-Port Switches)
Use a 0.144-inch (3.7 mm) or a #27 drill bit to drill a 1/2-inch (12.7 mm) hole in the three screw
Step 4
template slots.
Step 5
Insert three screws in the slots on the screw template, and tighten until they touch the top of the screw
template.
Step 6
Remove the screw template from the desk or shelf.
Step 7
Place the switch on the mounting screws, and slide it forward until it locks in place, as shown in
Figure
Figure 3-2
1
2
Under the Desk or Shelf Mounting
Locate the screw template. The template helps to align the mounting screw holes and is a guide to make
Step 1
sure the screws are installed under the desk or shelf with proper clearance.
Position the screw template underneath the desk or shelf so that the two side-by-side slots face the front
Step 2
of the desk or shelf, as shown in
or shelf after the switch is installed. Wait before you attach the screw template to the desk or shelf.
OL-6337-07
3-2.
Mounting the Switch on a Desk or Shelf With Mounting Screws
SYS T
STA T
CO NS OL
E
DPL X
1x
2x
SPD
3x
PoE
4x
5x
6x
MO DE
1
3
Slides on this way
Desk or shelf
Screws
4
Wall
7x
C at al ys t 35
8x
60
SE RIE S
P oE -8
1
2
Figure
3-3. This ensures that the power cord faces the rear of the desk
Catalyst 3560 Switch Hardware Installation Guide
Installing the Switch
3
3-9
Hide quick links:
Advertisement
Table of Contents
