Power On The Router - Cisco 12406 Installation And Configuration Manual
Configuration guide
Hide thumbs
Also See for 12406:
- Replacement instructions manual (44 pages) ,
- Unpacking instructions manual (16 pages) ,
- Product overview (52 pages)
Table of Contents
Advertisement
Chapter 3
Installing the Router
Power On the Router
Step 1
Step 2
Step 3
Step 4
OL-11497-03
To power on the router, follow these steps:
Either switch on all the circuit breakers or plug the power cord into an active
power source that controls power to the PDU in the router.
During the first-time startup, the system displays the system banner information.
Check the startup banner and displays to ensure that the system has restarted
properly and that all the interfaces reinitialize properly.
Check the power module LEDs. They should appear as described below:
For a router equipped with AC-input power supplies:
•
Green LED labeled AC—When the power module is fully seated in its
–
bay and is receiving source power within the required range, this LED
should be on. It indicates that AC power is present and is within specified
limits. The power supply fan should also be on.
Green LED labeled DC—Power supply is operating normally in a
–
powered-on condition.
For a router equipped with DC-input PEMs:
•
Green LED labeled INPUT OK—When the power module is fully seated
–
in its bay and is receiving source power within the required range, this
LED should be on. It indicates that DC power is present and is within
specified limits. The power supply fan should also be on.
Green LED labeled OUTPUT OK—DC-input PEM is operating normally
–
in a powered-on condition.
Amber LED labeled MISWIRE—Should be off. When it is on, it
–
indicates that the input is wired backward at the PDU input.
Go to the rear of the chassis and visually check the two LEDs on the front of the
blower module. They should appear as described below:
Green LED labeled OK—Should be on
•
Red LED labeled FAIL—Should be off
•
Listen for the blowers in the blower module; you should immediately hear them
operating.
Cisco 12006 and Cisco 12406 Router Installation and Configuration Guide
Power On the Router
3-35
Advertisement
Table of Contents
Troubleshooting
