Removing An Alarm Card; Installing An Alarm Card - Cisco 12406 Installation And Configuration Manual
Configuration guide
Hide thumbs
Also See for 12406:
- Replacement instructions manual (44 pages) ,
- Unpacking instructions manual (16 pages) ,
- Product overview (52 pages)
Table of Contents
Advertisement
Removing and Installing a Clock and Scheduler Card, Switch Fabric Card, or Alarm Card
Removing an Alarm Card
Step 1
Step 2
Step 3
Step 4
Step 5
Installing an Alarm Card
Step 1
Step 2
Caution
Step 3
Step 4
Step 5
Cisco 12006 and Cisco 12406 Router Installation and Configuration Guide
6-66
To remove an alarm card, see
Attach an ESD-preventive strap to your wrist and connect the leash to the chassis
or to another grounded, bare metal surface.
Loosen the captive screw on each side of the alarm card.
Grasp the handle on the front of the alarm card and slide the alarm card halfway
out of the slot, then stop.
Touching only the metal card carrier, use your free hand to support the bottom of
the alarm card.
Remove the card from the slot and place it directly into an antistatic bag or other
ESD-preventive container.
If you plan to return the defective alarm card to the factory, repackage it in the
shipping container you received with the replacement card.
To install an alarm card, see
Attach an ESD-preventive strap to your wrist and connect the leash to the chassis
or to another grounded, bare metal surface.
Remove the alarm card from its antistatic bag or ESD-preventive container.
Avoid touching the card circuitry or any connectors.
Touching only the handle, use your free hand to support the bottom of the alarm
card.
Slide the alarm card into the alarm card slot until it contacts the backplane, then
stop.
Use both thumbs to push the card carrier into the slot until the alarm card
connector seats itself against the backplane connector.
Figure 6-35
and follow these steps:
Figure 6-35
and follow these steps:
Chapter 6
Maintaining the Router
OL-11497-03
Advertisement
Table of Contents
Troubleshooting
