Wwn Secondary-Mac - Cisco AJ732A - MDS 9134 Fabric Switch Command Reference Manual

Cisco mds 9000 family command reference guide - release 4.x (ol-18089-01, february 2009)

Hide thumbs Also See for AJ732A - Cisco MDS 9134 Fabric Switch:

Table of Contents

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

wwn secondary-mac

To allocate secondary MAC addresses, use the wwn secondary-mac command.

Syntax Description

secondary-mac wwn-id The secondary MAC address with the format hh:hh:hh:hh:hh:hh.

range address-range

Command Modes

Command History

Usage Guidelines

This command cannot be undone.

Changes to the worldwide names are only performed as required. They should not be changed on a daily

basis. These changes should be made by an administrator or individual who is completely familiar with

switch operations.

For more information, refer to the Cisco MDS 9000 Family CLI Configuration Guide.

The following example allocates a secondary range of MAC addresses.

switch(config)# wwnm secondary-mac 00:99:55:77:55:55 range 64

This command CANNOT be undone.

Please enter the BASE MAC ADDRESS again: 00:99:55:77:55:55

Please enter the mac address RANGE again: 64

From now on WWN allocation would be based on new MACs.

Are you sure? (yes/no) no

You entered: no. Secondary MAC NOT programmed

OL-18089-01, Cisco MDS NX-OS Release 4.x

www secondary-mac wwn-id range address-range

The range for the specified WWN. The only valid value is 64.

Modification

This command was introduced.

Cisco MDS 9000 Family Command Reference

wwn secondary-mac