Cisco AJ732A - MDS 9134 Fabric Switch Command Reference Manual page 1628
Cisco mds 9000 family command reference guide - release 4.x (ol-18089-01, february 2009)
Hide thumbs
Also See for AJ732A - Cisco MDS 9134 Fabric Switch:
- Configuration manual (700 pages) ,
- Messages manual (518 pages) ,
- Installation manual (288 pages)
Table of Contents
Advertisement
zone name (configuration mode)
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
port-number port-number
fcalias name
fcid fcid-id
fwwn fwwn-id
interface fc slot/port
interface bay | ext port
swwn swwn-id
ip-address ip-address
subnet-mask
pwwn pwwn-id
symbolic-nodename
identifier
Defaults
Zone attribute is read-only.
Command Modes
Configuration mode.
Command History
Release
1.0(2)
1.2(1)
2.0(x)
3.1(2)
Usage Guidelines
Zones are assigned to zone sets, zone sets are then activated from one switch and propagate across the
fabric to all switches. Zones allow security by permitting and denying access between nodes (hosts and
storage). zone name commands are issued from the configuration mode. Configure a zone for a VSAN
from the config-zone submode.
Use the show wwn switch command to retrieve the sWWN. If you do not provide a sWWN, the software
automatically uses the local sWWN.
Broadcast frames are sent to all Nx ports.
If any NL port attached to an FL port shares a broadcast zone with the source of the
Cisco MDS 9000 Family Command Reference
27-14
Adds a member using the port number of the domain ID portnumber
association.
Adds a member using the fcalias name.
Adds a member using the FCID member in the format 0xhhhhhh.
Adds a member using the fabric port WWN in the format
hh:hh:hh:hh:hh:hh:hh:hh.
(Optional) Adds a member using the Fibre Channel interface to a
Cisco MDS 9000 Family switch.
(Optional) Adds a member using the Fibre Channel interface to a
Cisco Fabric Switch for HP c-Class BladeSystem or to a Cisco Fabric
Switch for IBM BladeCenter . The range is 0 to 48.
Specifies the switch WWN in the format hh:hh:hh:hh:hh:hh:hh:hh.
Adds a member using the IP address.
Specifies an optional subnet mask.
Adds a member using the port WWN in the format
hh:hh:hh:hh:hh:hh:hh:hh.
Adds a member using the symbolic node name in the form of a name
or an IP address.
Modification
This command was introduced.
Added the attribute, interface, and lun subcommands.
Added the broadcast and qos priority options to the attribute
•
subcommand.
Added the attribute-group subcommand.
•
Added the device-alias aliasname [lun lun-id] option to the member
•
subcommand.
Added the interface bay | ext option to the member subcommand.
Chapter 27
Z Commands
OL-18089-01, Cisco MDS NX-OS Release 4.x
Advertisement
Table of Contents
