System Switchover (Configuration Mode) - Cisco MDS 9124 - Fabric Switch Reference

Cisco mds 9000 family command reference - cisco mds san-os release 3.0(1) through 3.3(1a) (ol-16217-01, april 2008)

Hide thumbs Also See for Cisco MDS 9124 - Fabric Switch:

Table of Contents

system switchover (configuration mode)

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

system switchover (configuration mode)

To enable a switchover for the system, use the system switchover command in configuration mode. To

revert to the factory default setting, use the no form of the command.

Syntax Description

Command Modes

Configuration mode.

Command History

Usage Guidelines

The following example enables a HA switchover from an active supervisor module to a standby

supervisor module.

switch# config terminal

switch(config)# system switchover ha

Cisco MDS 9000 Family Command Reference

system switchover {ha | warm}

no system switchover

Specifies an HA switchover.

Specifies a warm switchover.

Modification

This command was introduced.

OL-16217-01, Cisco MDS SAN-OS Release 3.x