Tcp Pmtu-Enable - Cisco MDS 9124 - Fabric Switch Reference

Cisco mds 9000 family command reference - cisco mds san-os release 3.0(1) through 3.3(1a) (ol-16217-01, april 2008)

Hide thumbs Also See for Cisco MDS 9124 - Fabric Switch:

Table of Contents

tcp pmtu-enable

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

tcp pmtu-enable

To configure path MTU (PMTU) discovery, use the tcp pmtu-enable command. Use the no form of this

command to disable this feature or revert to its factory defaults.

Syntax Description

reset-timeout seconds

3600 seconds.

Command Modes

FCIP profile configuration submode.

Command History

Usage Guidelines

The following example configures a FCIP profile:

switch# config terminal

switch(config)# fcip profile 5

switch(config-profile)#

The following example disables PMTU discovery:

switch(config-profile)# no tcp pmtu-enable

The following example enables PMTU discovery with a default of 3600 seconds:

switch(config-profile)# tcp pmtu-enable

The following example specifies the PMTU reset timeout to 90 seconds:

switch(config-profile)# tcp pmtu-enable reset-timeout 90

The following example leaves the PMTU in an enabled state but changes the timeout to the default of

3600 seconds:

switch(config-profile)# no tcp pmtu-enable reset-timeout 600

Cisco MDS 9000 Family Command Reference

tcp pmtu-enable [reset-timeout seconds]

no tcp pmtu-enable [reset-timeout seconds]

Modification

This command was introduced.

Specifies the PMTU reset timeout. The range is 60 to 3600 seconds.

OL-16217-01, Cisco MDS SAN-OS Release 3.x