Zone Default-Zone - Cisco MDS 9124 - Fabric Switch Reference

Cisco mds 9000 family command reference - cisco mds san-os release 3.0(1) through 3.3(1a) (ol-16217-01, april 2008)

Hide thumbs Also See for Cisco MDS 9124 - Fabric Switch:

Table of Contents

zone default-zone

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

zone default-zone

To define whether a default zone (nodes not assigned a created zone) permits or denies access to all in

the default zone, use the zone default-zone command in configuration mode. Use the no form of the

command to negate the command or revert to the factory defaults.

Syntax Description

vsan vsan-id

All default zones are permitted access.

Command Modes

Configuration mode.

Command History

Usage Guidelines

Use the zone default-zone permit vsan command to define the operational values for the default zone

in a VSAN. This command applies to existing VSANs; it has no effect on VSANs that have not yet been

Use the system default zone default-zone permit command to use the default values defined for the

default zone for all VSANs. The default values are used when you initially create a VSAN and it

becomes active.

The following example permits default zoning in VSAN 2.

switch# config terminal

switch(config)# zone default-zone permit vsan 2

Related Commands

system default zone

default-zone permit

Cisco MDS 9000 Family Command Reference

zone default-zone [permit] vsan vsan-id

no zone default-zone [permit] vsan vsan-id

Permits access to all in the default zone.

Sets default zoning behavior for the specified VSAN. The ID of the VSAN

is from 1 to 4093.

Modification

This command was introduced.

Configures default values for a zone.

Displays zone information.

OL-16217-01, Cisco MDS SAN-OS Release 3.x