Periodic Notification; Message Severity Threshold - Cisco ASR1002 - ASR 1002 Router Software Configuration Manual
Asr 1000 series aggregation services routers
Hide thumbs
Also See for ASR1002 - ASR 1002 Router:
- Quick start manual (47 pages) ,
- Installation manual (46 pages) ,
- Configuration manual (34 pages)
Table of Contents
Advertisement
How to Configure Call Home
•
•
•
•
•
The triggering events for each alert group are listed in the
section on page
section on page
You can select one or more alert groups to be received by a destination profile.
A Call Home alert is only sent to destination profiles that have subscribed to the alert group containing
Note
that Call Home alert. In addition, the alert group must be enabled.
Periodic Notification
When you subscribe a destination profile to either the Configuration or the Inventory alert group, you
can choose to receive the alert group messages asynchronously or periodically at a specified time. The
sending period can be one of the following:
•
•
•
Message Severity Threshold
When you subscribe a destination profile to the Environment or Syslog alert group, you can set a
threshold for the sending of alert group messages based on the message's level of severity. Any message
with a severity lower than the specified threshold of the destination profile is not sent to the destination.
When syslog level is changed via IOS CLI, the new value is propagated to non-IOS processes as well,
Note
with the result that these processes no longer send syslog messages of lower priority to IOS to process,
thus "saving" CPU cycles for IOS
Table 1
level of urgency) to debugging (level 0, lowest level of urgency). If no severity threshold is configured,
the default is debugging (level 0). However, the default is not recommended due to the number of
messages that will be triggered.
Call Home severity levels are not the same as system message logging severity levels.
Note
Cisco ASR 1000 Series Aggregation Services Routers Software Configuration Guide
18
Configuration
Diagnostic
Environment
Inventory
Syslog
40, and the contents of the alert group messages are listed in the
42.
Daily—Specify the time of day to send, using an hour:minute format hh:mm, with a 24-hour clock
(for example, 14:30).
Weekly—Specify the day of the week and time of day in the format day hh:mm, where the day of
the week is spelled out (for example, monday).
Monthly—Specify the numeric date, from 1 to 31, and the time of day, in the format date hh:mm.
lists the keywords used to configure the severity, which range from catastrophic (level 9, highest
"Alert Group Trigger Events and Commands"
"Message Contents"
Configuring Call Home
Advertisement
Table of Contents
Troubleshooting
