Using Issu To Upgrade The Subpackages In A Dual Route Processor Configuration - Cisco ASR1002 - ASR 1002 Router Software Configuration Manual
Asr 1000 series aggregation services routers
Hide thumbs
Also See for ASR1002 - ASR 1002 Router:
- Quick start manual (47 pages) ,
- Installation manual (46 pages) ,
- Configuration manual (34 pages)
Table of Contents
Advertisement
ISSU Upgrade for Redundant Platforms
Compiled Thu 01-May-08 00:29 by mcpre
*Jul 21 23:43:31.978: %SSH-5-ENABLED: SSH 1.99 has been enabled
*Jul 21 23:43:35.196: Relay: standby progression done
*Jul 21 23:43:35.197: %PLATFORM-6-RF_PROG_SUCCESS: RF state STANDBY HOT
At this point of the procedure, use your UNIX client to log in to the other RP:
[unix-server-1 ~]$ telnet 172.17.52.157 2003
User Access Verification
Username: user
Password: ********
Router>
Router# issu acceptversion
Cancelling rollback timer
SUCCESS: Rollback timer cancelled
Router# issu commitversion
--- Starting installation changes ---
Cancelling rollback timer
Saving image changes
Finished installation changes
Building configuration...
[OK]
SUCCESS: version committed: bootflash:asr1000rp1-adventerprisek9.02.01.01.122-33.XNA1.bin
After you confirm the software versions and configuration, reload the RP as shown in the following
example:
Router# hw-module slot R0 reload
Proceed with reload of module? [confirm]
*Jul 21 23:54:27.271: %REDUNDANCY-3-STANDBY_LOST: Standby processor fault
(PEER_NOT_PRESENT)
*Jul 21 23:54:27.271: %REDUNDANCY-3-STANDBY_LOST: Standby processor fault (PEER_DOWN)
*Jul 21 23:54:27.271: %REDUNDANCY-3-STANDBY_LOST: Standby processor fault
(PEER_REDUNDANCY_STATE_CHANGE)
*Jul 21 23:57:05.528: %ASR1000_OIR-6-ONLINECARD: Card (rp) online in slot R0
*Jul 21 23:57:25.480: %REDUNDANCY-5-PEER_MONITOR_EVENT: Active detected a standby
insertion (raw-event=PEER_FOUND(4))
*Jul 21 23:57:25.480: %REDUNDANCY-5-PEER_MONITOR_EVENT: Active detected a standby
insertion (raw-event=PEER_REDUNDANCY_STATE_CHANGE(5))
*Jul 21 23:58:47.172: %HA_CONFIG_SYNC-6-BULK_CFGSYNC_SUCCEED: Bulk Sync succeeded
*Jul 21 23:58:47.173: %RF-5-RF_TERMINAL_STATE: Terminal state reached for (SSO)
Using ISSU to Upgrade the SubPackages in a Dual Route Processor Configuration
This section provides instructions on performing an ISSU upgrade on a Cisco ASR 1000 Series Router
with dual RPs that is currently running individual subpackages.
This section covers the following topics:
•
•
Cisco ASR 1000 Series Aggregation Services Routers Software Configuration Guide
12
Using ISSU to Upgrade the SubPackages on a Cisco ASR 1006 or ASR 1013 Router (issu Command
Set), page 13
Using ISSU to Upgrade SubPackages on a Cisco ASR 1006 Router or ASR 1013 Router (request
platform command set), page 46
Software Upgrade Process
Advertisement
Table of Contents
Troubleshooting
