Table of Contents
Advertisement
Chapter 52
Configuring QoS
When configuring the 1p7q8t ports, note the following:
Queue 1 is the lowest-priority standard transmit queue.
•
Queue 7 is the highest-priority standard transmit queue.
•
When configuring each standard transmit queue, note the following:
•
When configuring the 1p3q8t ports, note the following:
Queue 1 is the low-priority standard transmit queue.
•
Queue 2 is the medium-priority standard transmit queue.
•
Queue 3 is the high-priority standard transmit queue.
•
When configuring each standard transmit queue, note the following:
•
When configuring the 1p2q2t ports, note the following:
Queue 1 is the low-priority standard transmit queue.
•
Queue 2 is the high-priority standard transmit queue.
•
When configuring each standard transmit queue, note the following:
•
When configuring the 1p3q1t ports, note the following:
•
Queue 1 is the low-priority standard transmit queue.
Queue 2 is the medium-priority standard transmit queue.
•
Queue 3 is the high-priority standard transmit queue.
•
When you configure each standard transmit queue, the single percentage that you enter sets the
•
threshold.
When configuring the 1p2q1t ports, note the following:
Queue 1 is the low-priority standard transmit queue.
•
Queue 2 is the high-priority standard transmit queue.
•
When you configure each standard transmit queue, the single percentage that you enter sets the
•
threshold.
When configuring thresholds, note the following:
The thresholds are all specified as percentages ranging from 0–100. A value of 10 indicates a
•
threshold when the buffer is 10 percent full.
You can configure both the low WRED threshold and the high WRED threshold. You must set the
•
low threshold to a lower percentage than the high threshold.
OL-8978-04
The first percentage that you enter sets the lowest-priority threshold.
–
The second percentage that you enter sets the next highest-priority threshold.
–
–
The eighth percentage that you enter sets the highest-priority threshold.
The first percentage that you enter sets the lowest-priority threshold.
–
The second percentage that you enter sets the next highest-priority threshold.
–
–
The eighth percentage that you enter sets the highest-priority threshold.
The first percentage that you enter sets the low-priority threshold.
–
The second percentage that you enter sets the high-priority threshold.
–
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
Configuring QoS on the Switch
52-65
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
