Table of Contents
Advertisement
Chapter 39
Configuring the Switch Access Using AAA
Specifying the RADIUS Timeout Interval
You can specify the timeout interval between the retransmissions to the RADIUS server. The default
timeout is 5 seconds.
To specify the RADIUS timeout interval, perform this task in privileged mode:
Task
Step 1
Specify the RADIUS timeout interval.
Step 2
Verify the RADIUS configuration.
This example shows how to specify the RADIUS timeout interval and verify the configuration:
Console> (enable) set radius timeout 10
Radius timeout set to 10 seconds.
Console> (enable) show radius
Login Authentication:
---------------------
tacacs
radius
local
Enable Authentication: Console Session
---------------------- ----------------- ----------------
tacacs
radius
local
Radius Deadtime:
Radius Key:
Radius Retransmit:
Radius Timeout:
Radius-Server
----------------------------- -------
172.20.52.3
Console> (enable)
Specifying the RADIUS Retransmit Count
You can specify the number of times that the switch will attempt to contact a RADIUS server before the
next configured server is tried. By default, each RADIUS server is tried two times.
To specify the RADIUS retransmit count, perform this task in privileged mode:
Task
Step 1
Specify the RADIUS server retransmit count.
Step 2
Verify the RADIUS configuration.
OL-8978-04
Console Session
Telnet Session
----------------
----------------
disabled
disabled
enabled(primary)
enabled(primary)
enabled
enabled
Telnet Session
disabled
disabled
enabled(primary)
enabled(primary)
enabled
enabled
0 minutes
Secret_RADIUS_key
2
10 seconds
Status
Auth-port
------------
primary
1812
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
Configuring Authentication on the Switch
Command
set radius timeout seconds
show radius
Command
set radius retransmit count
show radius
39-29
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
