hit counter script

Cisco uBR10012 Troubleshooting Manual page 55

Universal broadband router
Hide thumbs Also See for uBR10012:
Table of Contents

Advertisement

Chapter 4
Troubleshooting Line Cards
If the crash is accompanied by %IPC-3-NOBUFF messages, see
Messages on the Cisco 12000, 10000 and 7500
http://www.cisco.com/en/US/products/hw/routers/ps133/products_tech_note09186a00800945a1.s
html
Hardware Problem—The card might not be fully inserted into its slot, or the card hardware itself
could have failed. In particular, if the problem began occurring after the card was moved or after a
power outage, the card could have been damaged by static electricity or a power surge. Only a small
number of fabric ping timeouts are caused by hardware failures, so check for the following before
replacing the card:
If software-forced crashes continue, collect the following information and contact Cisco TAC:
All relevant information about the problem that you have available, including any troubleshooting
you have performed.
Any console output that was generated at the time of the problem.
Output of the show tech-support command.
Output of the show log command (or the log that was captured by your SYSLOG server, if
available).
For information on contacting TAC and opening a case, see the
on page
OL-1237-01
Reload the software on the line card, using the hw-module slot reset command.
Remove and reinsert the line card in its slot.
Try moving the card to another slot, if one is available.
x.
General Information for Troubleshooting Line Card Crashes
Series, at the following URL:
"Obtaining Technical Assistance" section
Cisco uBR10012 Universal Broadband Router Troubleshooting Guide
Troubleshooting IPC-3-NOBUFF
4-7

Advertisement

Table of Contents
loading

Table of Contents