Appendix; Unsupported Commands; Unsupported Frame Relay Commands - Cisco uBR10012 Troubleshooting Manual
Universal broadband router
Hide thumbs
Also See for uBR10012:
- Hardware installation manual (280 pages) ,
- Software configuration manual (240 pages) ,
- Quick start manual (72 pages)
Table of Contents
Advertisement
Unsupported Commands
The following are lists of the commands that are present but not supported for the
Cisco uBR10012 router in various releases of the Cisco IOS software.
•
•
•
•
•
•
•
Cisco strongly advises against using unsupported Cisco IOS commands, even if described, because such
Warning
commands can have undesirable effects upon the performance of the Cisco CMTS. In particular, Cisco advises
against using any unsupported commands that pertain to service-policy or to Modular Quality of Service
command-line interface (MQC) while Parallel Express Forwarding (PXF) is running on the Cisco CMTS.
Such commands may cause the Cisco CMTS to hang with unpredictable recovery times.
Unsupported Frame Relay Commands
The following commands are not supported in any Cisco IOS software release.
•
•
•
•
•
•
•
•
•
•
OL-1237-01
Unsupported Frame Relay Commands, page A-1
HCCP Commands, page A-2
MLPPP Commands, page A-2
Unsupported MPLS VPN Commands, page A-3
Unsupported PPP Commands, page A-3
Spectrum Management Commands, page A-3
Unsupported Telco-Return Commands, page A-3
FRF.12 fragmentation commands
FRF.11 VoFR commands
frame-relay adaptive-shaping {becn | foresight}
frame-relay bc {in | out} bits
frame-relay be {in | out} bits
frame-relay cir {in | out} bps
frame-relay custom-queue-list list-number
frame-relay de-group group-number dlci
frame-relay ip [rtp | tcp] header-compression [passive]
frame-relay map protocol protocol-address dlci [broadcast] [ietf | cisco] [payload-compress
{packet-by-packet | frf9 stac [hardware-options]}]
A P P E N D I X
Cisco uBR10012 Universal Broadband Router Troubleshooting Guide
A
A-1
Advertisement
Table of Contents
Troubleshooting
