Chapter 5
Troubleshooting the Cisco IPVC 3500 Series Gateway
Procedure
Step 1
At the prompt for the command line options, press P to change the software password and then press
Enter.
At the "Enter user name" prompt, enter the name that you want to use and then press Enter. The user
Step 2
name is case sensitive.
At the "Enter new password" prompt, enter the password that you want to use and then press Enter. The
Step 3
password is case sensitive.
A message appears verifying that the password is changed and the command line options appear.
Enter Q to continue the gateway module boot cycle and then press Enter.
Step 4
Setting Echo Cancellation
This section applies only to Cisco IPVC 3521 BRI Gateways.
Note
You can use these advanced commands to set echo cancellation for the Cisco IPVC 3521 BRI Gateway.
To set echo cancellation, perform the following steps:
Procedure
At the prompt for the command line options, press A to display the advanced command menu.
Step 1
Press 1 to enable or disable echo cancellation for voice-only calls and then press Enter.
Step 2
Step 3
At the "0/1-disable/enable echo cancellation (voice calls)" prompt, do one of the following:
•
•
Press Enter.
Step 4
Configuring the Web Server Port
You can set the port number that the Cisco IPVC 3500 Series Gateway uses for posting its web pages.
The default value is 80, which is the standard for web server ports. If another port is used in your
environment, you can use this command to change the gateway module web server port setting.
Procedure
At the prompt for the command line options, press A to display the advanced command menu.
Step 1
Press 2 and then press Enter to configure the web server port.
Step 2
Administrator's Guide for Cisco IPVC 3521 BRI Gateway, Cisco IPVC 3526 PRI Gateway, and Cisco IPVC 3540 PRI Gateway
OL-7995-01
Press 0 to disable echo cancellation.
Press 1 to enable echo cancellation.
Using the Hyperterminal Configuration Commands
5-9