Errdisable Detect Cause - Cisco Catalyst 3030 Command Reference Manual

Blade switch

Hide thumbs Also See for Catalyst 3030:

Table of Contents

Cisco Catalyst Blade Switch 3030 Cisco IOS Commands

errdisable detect cause

Use the errdisable detect cause global configuration command to enable error-disabled detection for a

specific cause or all causes. Use the no form of this command to disable the error-disabled detection

Syntax Description

dhcp-rate-limit

gbic-invalid

Command Default

Detection is enabled for all causes.

Command Modes

Global configuration

Command History

errdisable detect cause {all | dhcp-rate-limit | dtp-flap | gbic-invalid | link-flap | loopback |

no errdisable detect cause {all | dhcp-rate-limit | dtp-flap | gbic-invalid | link-flap | pagp-flap}

Enable error detection for all error-disabled causes.

Enable error detection for DHCP snooping.

Enable error detection for the Dynamic Trunking Protocol (DTP) flapping.

Enable error detection for an invalid Gigabit Interface Converter (GBIC) module.

This error refers to an invalid small form-factor pluggable (SFP) module.

Enable error detection for link-state flapping.

Enable error detection for detected loopbacks.

Enable error detection for the Port Aggregation Protocol (PAgP) flap

error-disabled cause.

Modification

This command was introduced.

Cisco Catalyst Blade Switch 3030 Command Reference

errdisable detect cause