Mac Address-Table Static - Cisco Catalyst 3030 Command Reference Manual

Blade switch

Hide thumbs Also See for Catalyst 3030:

Table of Contents

mac address-table static

Use the mac address-table static global configuration command to add static addresses to the MAC

address table. Use the no form of this command to remove static entries from the table.

Syntax Description

vlan vlan-id

interface interface-id

No static addresses are configured.

Command Modes

Global configuration

Command History

This example shows how to add the static address c2f3.220a.12f4 to the MAC address table. When a

packet is received in VLAN 4 with this MAC address as its destination, the packet is forwarded to the

specified interface:

Switch(config)# mac address-table static c2f3.220a.12f4 vlan 4 interface

gigabitethernet0/1

You can verify your setting by entering the show mac address-table privileged EXEC command.

Related Commands

show mac address-table static

Cisco Catalyst Blade Switch 3030 Command Reference

mac address-table static mac-addr vlan vlan-id interface interface-id

no mac address-table static mac-addr vlan vlan-id [interface interface-id]

Modification

This command was introduced.

Destination MAC address (unicast or multicast) to add to the address

table. Packets with this destination address received in the specified

VLAN are forwarded to the specified interface.

Specify the VLAN for which the packet with the specified MAC address

is received. The range is 1 to 4094.

Interface to which the received packet is forwarded. Valid interfaces

include physical ports and port channels.

Displays static MAC address table entries only.

Cisco Catalyst Blade Switch 3030 Cisco IOS Commands