Cisco Catalyst 3030 Command Reference Manual page 454
Blade switch
Hide thumbs
Also See for Catalyst 3030:
- Getting started manual (34 pages) ,
- Getting started (122 pages)
Table of Contents
Advertisement
snmp-server enable traps
ospf [cisco-specific |
errors | lsa | rate-limit |
retransmit |
state-change]
pim
[invalid-pim-message |
neighbor-change |
rp-mapping-change]
port-security
[trap-rate value]
rtr
snmp [authentication |
coldstart | linkdown |
linkup | warmstart]
storm-control
trap-rate value
stpx
syslog
tty
vlan-membership
vlancreate
vlandelete
vtp
Cisco Catalyst Blade Switch 3030 Command Reference
2-426
Chapter 2 Cisco Catalyst Blade Switch 3030 Cisco IOS Commands
(Optional) Enable Open Shortest Path First (OSPF) traps. The keywords have
these meanings:
cisco-specific—(Optional) Enable Cisco-specific traps.
•
•
errors—(Optional) Enable error traps.
lsa—(Optional) Enable link-state advertisement (LSA) traps.
•
rate-limit—(Optional) Enable rate-limit traps.
•
retransmit—(Optional) Enable packet-retransmit traps.
•
state-change—(Optional) Enable state-change traps.
•
(Optional) Enable Protocol-Independent Multicast (PIM) traps. The
keywords have these meanings:
invalid-pim-message—(Optional) Enable invalid PIM message traps.
•
neighbor-change—(Optional) Enable PIM neighbor-change traps.
•
•
rp-mapping-change—(Optional) Enable rendezvous point
(RP)-mapping change traps.
(Optional) Enable port security traps. Use the trap-rate keyword to set the
maximum number of port-security traps sent per second. The range is from
0 to 1000; the default is 0 (no limit imposed; a trap is sent at every
occurrence).
(Optional) Enable SNMP Response Time Reporter traps.
(Optional) Enable SNMP traps. The keywords have these meanings:
•
authentication—(Optional) Enable authentication trap.
coldstart—(Optional) Enable cold start trap.
•
linkdown—(Optional) Enable linkdown trap.
•
linkup—(Optional) Enable linkup trap.
•
warmstart—(Optional) Enable warmstart trap.
•
(Optional) Enable storm-control traps. Use the trap-rate keyword to set the
maximum number of storm-control traps sent per second. The range is 0 to
1000; the default is 0 (no limit is imposed; a trap is sent at every occurrence).
(Optional) Enable SNMP STPX MIB traps. The keywords have these
meanings:
inconsistency—(Optional) Enable SNMP STPX MIB Inconsistency
•
Update traps.
root-inconsistency—(Optional) Enable SNMP STPX MIB Root
•
Inconsistency Update traps.
loop-inconsistency—(Optional) Enable SNMP STPX MIB Loop
•
Inconsistency Update traps.
(Optional) Enable SNMP syslog traps.
(Optional) Send TCP connection traps. This is enabled by default.
(Optional) Enable SNMP VLAN membership traps.
(Optional) Enable SNMP VLAN-created traps.
(Optional) Enable SNMP VLAN-deleted traps.
(Optional) Enable VLAN Trunking Protocol (VTP) traps.
78-17262-01
Advertisement
Table of Contents
