Installing Memory - IBM 8302 Hardware Maintenance Manual
Ibm computer hardware user manual
Hide thumbs
Also See for 8302:
- Guide utilisateur (124 pages) ,
- Benutzerhandbuch (122 pages) ,
- Guida per l'utente (120 pages)
Table of Contents
Advertisement
The following illustration shows the locations of parts on the system board.
1 Microprocessor
2 DIMM connector 1
3 DIMM connector 2
4 Power connector
5 Diskette drive connector
6 Primary IDE connector
7 Front panel connector
8 Secondary IDE connector
Installing memory
Your computer has two connectors for installing dual inline memory modules
(DIMMs) that provide up to a maximum of 2.0 GB of system memory.
When installing DIMMs, the following rules apply:
v Fill each system memory connector sequentially, starting at DIMM connector 1.
v Use 2.5 V, 184-pin, 266 MHz double data rate synchronous dynamic random
access memory (DDR SDRAM).
v Use 128 MB, 256 MB, 512 MB or 1.0 GB (when available) DIMMs in any
combination.
v DIMMs are 38.1 mm (1.5 inches) in height.
Note: Only DDR SDRAM DIMMs can be used.
To install a DIMM:
1. Remove the cover. See "Removing the cover" on page 40.
2. To locate the DIMM connectors. See "Identifying parts on the system board" on
page 44.
9 Battery
10 Clear CMOS/Recovery jumper
11 SCSI LED connector
12 PCI slots
13 Front panel audio connector
14 CD-ROM audio connector
15 AGP slot (some models)
16 Serial connector
Chapter 5. Installing Options
47
Hide quick links:
Advertisement
Table of Contents
