Table of Contents
Advertisement
Diagnostic Error Code
015-015-XXXUSB port External Loopback
failure
015-027-XXXUSB port Configuration/Setup
error
015-032-XXXUSB port Device Controller failure 1. System board
015-034-XXXUSB port bufferallocation failure
015-035-XXXUSB port Reset condition detected 1. Remove USB device(s) and re-test
015-036-XXXUSB port Register error
015-040-XXXUSB port IRQ failure
015-195-XXXUSB port Test aborted by user
015-196-XXXUSB port test halt, error threshold
exceeded
015-197-XXXUSB port test warning
015-198-XXXUSB port test aborted
015-199-XXXUSB port test failed, cause
unknown
018-000-XXXPCI Card Test Passed
10
Hardware Maintenance Manual: IBM NetVista Computer Types 6058, 6059, 6269, 6568, 6569, 6578, 6579, 6648,
6649
FRU/Action
1. Remove USB device(s) and re-test
2. System board
1. Flash the system
2. System board
1. Reboot the system
2. Flash the system
3. Run memory test
4. System board
2. System board
1. System board
1. Run setup and check for conflicts
2. Flash the system
3. System board
1. Information
2. Re-start the test, if necessary
1. Press F3 to review the log file
2. Re-start the test to reset the log file
1. Make sure the component that is called out is
connected and/or enabled
2. Re-run test
3. Component that is called out in warning statement
4. Component under test
1. If a component is called out, make sure it is
connected and/or enabled
2. Flash the system and re-test
3. Go to the "Undetermined problems" section
1. Go to the "Undetermined problems" section
2. Flash the system and re-test
3. Replace component under function test
1. No action
Hide quick links:
Advertisement
Table of Contents
