Message Check; Procedure 2 - Toshiba Satellite T130 Maintenance Manual
Hide thumbs
Also See for Satellite T130:
- Manual del usuario (239 pages) ,
- User manual (225 pages) ,
- Resource manual (56 pages)
Table of Contents
Advertisement
Chapter 2 Troubleshooting Procedures
Procedure 2
Message Check
When the power is turned on, the system performs the Initial Reliability Test (IRT) installed
in the BIOS ROM. When the test detects an error, an error message is displayed on the scree
Make sure no floppy disk is in the FDD. Turn on the computer and check the message on the
screen. Wh
en an OS starts from the 2.5" HD
Check 1 be
low and perfo m the other check
Check 1
If either of the following mess
messages do not appear, perform Check 3.
Insert system disk in drive
Press any key when ready .....
Non-System disk or disk error
Replace and press any key when ready
Check 2
Using the SYS command of the Free-DOS; transfer the system to the 2.5" HDD.
If the system is not transferred, go to Procedure 3. Refer to the Free-DOS Manual
for detailed operation.
If the following message appears on the display, the system program has been
transferred to the HDD.
System Transferred
If an error message appears on the display, perform Check 3.
Check 3
2.5" HDD(s) and the connector(s) of system board may be defective (Refer to the
steps described in Chapter 4, Replacement Procedures for disassembling.). Ins
HDD(s) to the connector(s) firmly. If it is (or they are) firmly connected, go to
Procedure 3.
Satellite T130, Satellite Pro T130 and PORTEGE T130Maintenance Manual (960-Q08)
D, go to Procedure 3. Otherwise, start with
r
s as instructed.
ages appears, go to Check 2. If the following
or
n.
ert
- Quick Links:
- Chapter 1 Hardware Overview
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
