Table of Contents
Advertisement
4 Replacement Procedures
4.8
MDC
NOTE: In the case of without MDC model, a block is installed instead of a MDC.
Removing the MDC
The following describes the procedure for removing the MDC (See Figure 4-15).
1. Remove the following screws securing the MDC.
2. Lift the MDC straight above to remove it from the connector CN3010 on the system
board.
3. Disconnect the modem cable from the connector on the MDC.
4-24
Downloaded from LpManual.com Manuals
• M2.0×4B
BIND screw
M2.0x4B BIND
MDC
CN3010
Figure 4-15 Removing the MDC
[CONFIDENTIAL]
×2
Modem cable
QOSMIO G40 Maintenance Manual (960-632)
4.8 MDC
Advertisement
Chapters
Table of Contents
Troubleshooting
