Table of Contents
Advertisement
2.6 2.5" HDD Troubleshooting
2.6
2.5" HDD Troubleshooting
To check if the 2.5" HDD is malfunctioning or not, follow the troubleshooting procedures
below as instructed.
CAUTION: The contents of the hard disk will be erased when the 2.5"HDD
Procedure 1
Insert the Toshiba MS-DOS system disk and start the computer. Perform the following
checks:
Check 1
Check 2
Check 3
Check 4
QOSMIO G40 Maintenance Manual (960-632)
Downloaded from LpManual.com Manuals
Procedure 1: Partition Check
Procedure 2: Message Check
Procedure 3: Format Check
Procedure 4: Diagnostic Test Program Execution Check
Procedure 5: Connector Check and Replacement Check
troubleshooting procedures are executed. Transfer the contents of the hard
disk to floppy disks or other storage drive(s). For the backup, refer to the
User's Manual.
Partition Check
Input C: and press Enter. If you cannot change to drive C, go to Check 2. If you
can change to drive C, go to Procedure 2.
Input FDISK and press Enter. Choose Display Partition Information from the
FDISK menu. If drive C is listed in the Display Partition Information, go to Check
3. If drive C is not listed, return to the FDISK menu and choose the option to
create a DOS partition or a logical DOS drive on drive C. If the problem still
occurs, go to Procedure 2.
If drive C is listed as active in the FDISK menu, go to Check 4. If drive C is not
listed as active, return to the FDISK menu and choose the option to set the active
partition for drive C. Then go to Procedure 2.
Remove the system disk from the FDD and reboot the computer. If the problem
still occurs, go to Procedure 2. Otherwise, the 2.5" HDD is operating normally.
2 Troubleshooting Procedures
[CONFIDENTIAL]
2-43
Advertisement
Chapters
Table of Contents
Troubleshooting
