Toshiba TECRA A10 Satellite Pro S300 Series User Manual page 101
Hide thumbs
Also See for TECRA A10 Satellite Pro S300 Series:
- Maintenance manual (464 pages) ,
- User manual (251 pages) ,
- User manual (56 pages)
Table of Contents
Advertisement
How to Swipe your Finger
Using the following steps when swiping fingers for fingerprint registration or
authentication will help to minimize authentication failures:
Align the first joint of the finger to the center of the sensor. Lightly touch the
sensor and swipe finger levelly towards you until the sensor surface
becomes visible. In performing this process, you should also take care to
ensure that the center of your fingerprint is on the sensor.
The following illustrations show the recommended way to swipe your finger
over the fingerprint sensor.
■
■
■
Downloaded from LpManual.com Manuals
User's Manual
Avoid swiping with your finger stiff or pressed too hard onto the sensor,
and take care to ensure that the center of the fingerprint is touching the
sensor before swiping. Either of these conditions may cause fingerprint
reading to fail.
Check the center of the fingerprint whorl before swiping and then
ensure this is swiped along the center line of the sensor.
There is a possibility of authentication failures if the finger is swiped too
quickly or too slowly - follow any on-screen instructions to adjust the
speed used during the swipe process.
Sensor
Figure 4-3 Swipe the finger
Operating Basics
Sensor
4-4
Advertisement
Chapters
Table of Contents
