Ground Terminal (U); Digital Audio Signal Input/Output; Main Power Switch - Sony XDS-PD1000 Operation Manual
Professional media station
Hide thumbs
Also See for XDS-PD1000:
- Operation manual (161 pages) ,
- Operations & installation manual (60 pages) ,
- Brochure & specs (28 pages)
Table of Contents
Advertisement
the data independent of the setting for CHAR SEL with the
setting for setup menu item 027.
1) You can set E-E signal output at all times using setup menu item 156
MONITOR OUT SELECT to REC port.
See "Basic Operations of the Function Menu" (page 48)
for more information about the CHAR SEL settings.
See page 107 for more information about the setup menu
item 027 SD CHARACTER.
2 Timecode input/output section
1 TIME CODE IN/OUT2 connector
a TIME CODE IN/OUT2 connector (BNC type)
This inputs an SMPTE timecode signal generated by an
external device.
b TIME CODE OUT1 connector (BNC type)
This outputs playback timecode signal.
3 Power supply section
1 Main power switch
3 Ground terminal
a Main power switch
Press the upper side to power the unit on. Press the lower
side to power the unit off.
When using the unit, normally leave the main power
switch in the on position, and use the on/standby button on
the front panel to switch the unit between the operating
state and standby state.
32
Rear Panel
2 TIME CODE OUT1
connector
2 AC power input connector
Note
Before turning the main power off, always check to be sure
that the on/standby indicator on the front panel is lit in red
(showing that this unit is in the standby state), and then
press the main power switch to the off side.
b AC power input connector (-)
Connect to an AC power supply with the power cord (not
supplied).
c Ground terminal (U)
Connect this to ground as required.
4 Digital audio signal input/output
section
1 DIGITAL AUDIO (AES/EBU) IN 1/2, 3/4, 5/6,
7/8 connectors
2 DIGITAL AUDIO (AES/EBU) OUT 1/2, 3/4, 5/6,
7/8 connectors
a DIGITAL AUDIO (AES/EBU) IN (digital audio
input) 1/2, 3/4, 5/6, 7/8 connectors (BNC type)
These input AES/EBU format digital audio signals.
b DIGITAL AUDIO (AES/EBU) OUT (digital audio
output) 1/2, 3/4, 5/6, 7/8 connectors (BNC type)
These output AES/EBU format digital audio signals.
In VTR mode, the playback signal is output when the unit
is playing a clip, and the E-E signal is output when the unit
is recording or set to E-E mode.
To treat the input and output signals of these connectors as
non-audio signals, set the maintenance menu item M37:
AUDIO CONFIG >M372: NON-AUDIO INPUT
(recording) (see page 129).
- Quick Links:
- Error Messages
Hide quick links:
Advertisement
Table of Contents
