Table of Contents
Advertisement
You can use any combination of up to 16 characters in the system owner's name.
To delete the system owner's name, select Delete stored system owners name;
then, press Enter.
Start Options
Start options take effect when you start your server.
You can select keyboard operating characteristics, such as the keyboard speed.
You also can specify whether the keyboard number lock starts on or off. You also
can enable the server to run without a diskette drive, monitor, or keyboard.
The server uses a startup sequence to determine the device from which the
operating system loads. For example, you can define a startup sequence that
checks for a startable diskette in the diskette drive, then checks the hard disk drive
in bay 1, and then checks a network adapter.
You can also select which PCI SCSI adapter is given boot precedence. The first
drive that is attached to the selected adapter will be assigned drive number 80L
and the operating system will start from that drive. The default for boot precedence
is Disabled. The range of choices depends upon the number of PCI SCSI adapters
installed in the server.
You can enable a virus-detection test that checks for changes in the master boot
record at startup. You also can choose to run POST in the enhanced mode or the
quick mode.
Select Start Options; then, use the Left or Right Arrow key to advance through
each data field.
The Start Options choice appears only on the full Configuration/Setup Utility main
menu.
Advanced Setup
Select Advanced Setup to change values for advanced hardware features, such
as cache control, and PCI configuration.
A warning message displays above the choices on this menu, to alert you that the
system might malfunction if these options are configured incorrectly. Follow the
instructions on the screen carefully.
Use the Left or Right Arrow key to scroll through each data field after you select
one of the setup options.
The Advanced Setup choice appears only on the full Configuration/Setup Utility
main menu.
2. Type the name in the Enter system owner's name string data field.
3. Press the Down Arrow key to select the Set or change system owner's name
data field.
4. Press Enter to set the name or change a previously defined name.
Chapter 3. Configuring your server
27
Advertisement
Table of Contents
Troubleshooting
