Table of Contents
Advertisement
Replacing the upper bezel
This procedure applies only to the 5U server model with hot-swap power supplies.
To install the upper bezel on the 5U server model with hot-swap power supplies,
complete the following steps.
1. Read the safety information in "Safety" on page vii and "Installation
2. Insert the two tabs on the right-side of the upper bezel into the corresponding
Bezel clips
Figure 91. Upper bezel installation for 5U server model with hot-swap power supplies
3. Rotate the upper bezel to the left side of the chassis until the bezel clips are
4. Unlock and remove the side cover (see "Replacing the lower bezel" on page
5. Remove the lower bezel (see "Replacing the side cover" on page 182).
6. Reconnect the external cables and power cords; then, turn on the attached
192
System x3100 M5 Type 5457: Installation and Service Guide
guidelines" on page 35.
holes on the right side of the chassis.
aligned with the corresponding indentations on the left side of the chassis and
snap them into place.
190).
devices and turn on the server.
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
