Table of Contents
Advertisement
1. Read the safety information in "Safety" on page vii and "Installation
2. Disconnect the power cord from the power supply that is to be removed.
3. Press down on the orange release lever and pull the power supply out of the
Release
lever
Figure 179. Hot-swap power supply removal for 5U server model with hot-swap power
supplies
4. If you are instructed to return the power supply, follow all packaging
Replacing the hot-swap power supply
This procedure applies only to the 5U server model with hot-swap power supplies.
The following items describe the type of power supply that the server supports
and other information that you must consider when you install a power supply:
v To confirm that the server supports the power supply that you are installing, see
v The server comes standard with one 430-watt hot-swap power supply. The input
v These power supplies are designed for parallel operation. In the event of a
v The server can run fully configured with one power supply. For redundancy
Note: You cannot mix high-efficiency and non-high-efficiency power supplies in
the server.
Statement 5
264
System x3100 M5 Type 5457: Installation and Service Guide
guidelines" on page 35.
bay, using the handle.
Hot-swap
power supply
instructions, and use any packaging materials for shipping that are supplied to
you.
http://www.ibm.com/systems/info/x86servers/serverproven/compat/us.
voltage is 110 V ac or 220 V ac auto-sensing.
power-supply failure, the redundant power supply continues to power the
system. The server supports a maximum of two power supplies.
support, you must install the second hot-swap power supply.
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
