Mitsubishi Electric Q173DSCPU Programming Manual page 164
Motion controller q series
Hide thumbs
Also See for Q173DSCPU:
- Programming manual (624 pages) ,
- Programming manual (556 pages) ,
- Programming manual (352 pages)
Table of Contents
Advertisement
7 SYNCHRONOUS CONTROL
(9) [Pr.430] Slippage amount at auxiliary shaft clutch ON
(D15042+150n, D15043+150n)
Set the slippage amount at clutch ON when the slippage method is set in [Pr.428]
Auxiliary shaft clutch smoothing method (D15040+150n).
The slippage amount is set in units based on the current value selected in
[Pr.423] Auxiliary shaft clutch reference address setting (D15031+150n).
If the set amount is negative, the slippage amount at clutch ON is controlled as 0
(direct).
(10) [Pr.431] Slippage amount at auxiliary shaft clutch OFF
(D15044+150n, D15045+150n)
Set the slippage amount at clutch OFF when the slippage method is set in
[Pr.428] Auxiliary shaft clutch smoothing method (D15040+150n).
The slippage amount is set in units based on the current value selected in
[Pr.423] Auxiliary shaft clutch reference address setting (D15031+150n).
If the set amount is negative, the slippage amount at clutch OFF is controlled as
0 (direct).
7 - 25
Hide quick links:
Advertisement
Table of Contents
