Cisco 500 series Administration Manual page 416
Stackable managed switch
Hide thumbs
Also See for 500 series:
- Configuration manual (1140 pages) ,
- Administration manual (653 pages) ,
- Quick start manual (72 pages)
Table of Contents
Advertisement
Configuring Quality of Service
Configuring QoS - General
STEP 1
STEP 2
STEP 3
STEP 4
STEP 1
STEP 2
Cisco 500 Series Stackable Managed Switch Administration Guide
Setting QoS Properties
To select the QoS mode:
Click Quality of Service > General > QoS Properties. The QoS Properties page
is displayed.
Set the QoS mode. The following options are available:
•
Disable—QoS is disabled on the device.
•
Basic—QoS is enabled on the device in Basic mode.
•
Advanced—QoS is enabled on the device in Advanced mode.
Select Port/LAG and click GO to display/modify all ports/LAGs on the device and
their CoS information.
The following fields are displayed for all ports/LAGs:
•
Interface—Type of interface.
•
Default CoS—Default VPT value for incoming packets that do not have a
VLAN Tag. The default CoS is 0. The default is only relevant for untagged
frames and only if the system is in Basic mode and Trust CoS is selected in
the Global Settings page.
Select Restore Defaults to restore the factory CoS default setting for this
interface.
Click Apply. The Running Configuration file is updated.
To set QoS on an interface, select it, and click Edit. The Edit Interface CoS
Configuration page is displayed.
Enter the parameters.
•
Interface—Select the port or LAG.
•
Default CoS—Select the default CoS (Class-of-Service) value to be
assigned for incoming packets (that do not have a VLAN tag). The range is
0-7.
Click Apply. The interface default CoS value is written to Running Configuration
file.
25
416
Hide quick links:
Advertisement
Table of Contents
