Replacing The Adapter - IBM System x3800 Problem Determination And Service Manual
Type 8866
Hide thumbs
Also See for System x3800:
- Manual (196 pages) ,
- User manual (104 pages) ,
- Installation manual (88 pages)
Table of Contents
Advertisement
2. If the adapter is not hot-pluggable, turn off the server and peripheral devices,
3. Unlock the front cover (tower model only) and remove the top cover (see
4. Disconnect any cables from the adapter.
5. Open the blue PCI retaining bar by lifting the front edge.
6. Push the orange adapter retention latch toward the rear of the server and open
7. Carefully grasp the adapter by its top edge or upper corners, and pull the
8. If you are instructed to return the adapter, follow all packaging instructions, and
Replacing the adapter
To install the replacement PCI adapter, complete the following steps:
10. Turn on all attached devices and the server.
120
IBM System x3800 Type 8866: Problem Determination and Service Guide
and disconnect the power cords and all external cables necessary to remove or
install the adapter.
"Removing the top cover, bezel, and front cover" on page 117).
the tab. The power LED for the slot turns off if an adapter is installed in the slot.
adapter from the server.
use any packaging materials for shipping that are supplied to you.
1. See the documentation that comes with the adapter for instructions for setting
jumpers or switches and for cabling.
Note: Route adapter cables before you install the adapter.
2. Carefully grasp the adapter by its top edge or upper corners, and align it with
the connector on the PCI board.
3. If necessary, remove the adapter guide before installing a full-length adapter.
4. Press the adapter firmly into the adapter connector.
5. Push down on the blue PCI retaining bar to stabilize the adapter.
6. Close the tab; then, push down on the orange adapter retention latch until it
clicks into place, securing the adapter.
7. Connect any required cables to the adapter.
8. Install the top cover and lock the front cover (tower model only) (see
"Replacing the top cover, bezel, and front cover" on page 119).
9. Connect the cables and power cords (see "Connecting the cables" on page
116 for cabling instructions).
- Quick Links:
- Light Path Diagnostics
Hide quick links:
Advertisement
Table of Contents
