Installing The Kickstand (Models 04054 And 04056); Installing The Transport Wheel Shafts (Models 04055 And 04056) - Toro Greensmaster 800 Operator's Manual
Hide thumbs
Also See for Greensmaster 800:
- Operator's manual (44 pages) ,
- Operator's manual (32 pages) ,
- Operator's manual (40 pages)
Table of Contents
Advertisement
Adjusting the Handle
1. Remove the hairpin cotters from the ring pins on each
side of the machine
2. While supporting the handle, remove the ring pins
from each side and raise or lower the handle to the
desired operating position
3. Install the ring pins and hairpin cotters.
2
Installing the Kickstand
(Models 04054 and 04056)
Parts needed for this procedure:
1
Kickstand assembly
1
Spring
Procedure
Note: The fasteners are shipped loosely installed on the
kickstand assembly.
1. On Model 04056 only, connect the spring stud to the
right-hand side of the kickstand
bolt, washer, and flange nut provided.
2
1
1. Bolt
2. Spring stud
2. Hook the spring into the hole in the spring bracket and
onto the spring stud while aligning the kickstand with
the mounting holes in the rear frame
(Figure
2).
(Figure
2).
(Figure
5) using the
4
3
G017948
Figure 5
3. Washer
4. Flange nut
(Figure
6).
1. Kickstand
2. Spring bracket
3. Mount the kickstand to each side of the frame with a
bolt, spacer, flat washer, and locknut
Note: Position the spacer in the kickstand mounting
hole.
3
Installing the Transport Wheel
Shafts (Models 04055 and
04056)
Parts needed for this procedure:
1
Right wheel shaft
1
Left wheel shaft
Procedure
1. Push the kickstand down with your foot and pull up
the handle to support the machine on the kickstand.
2. Apply thread-locking adhesive to the threads of the
wheel shafts.
3. Thread the right wheel shaft into the drive pulley on
the right side of the machine
Note: The right wheel shaft has left-hand threads.
g017948
10
Figure 6
3. Spring stud
4. Spring
(Figure
6).
(Figure
7).
g007594
Advertisement
Table of Contents
