Table of Contents
Advertisement
• Trim the straps to length and use the provided clips to terminate the strap end.
2. Align the sled assembly with the arm band and press
on the sled until it latches onto the arm band. Be sure
to align tabs on the back of sled with the notches on
the arm band. The end of the sled with the ring
scanner connector must face toward the hand.
3. If using the ring scanner (see
Scanner (Optional)
scanner over the index finger and adjust the strap (if
applicable) for a comfortable fit.
4. To remove the sled assembly, unbuckle and loosen the straps. It is not necessary to remove the strap from the buckle.
2 - 4
Connect the Ring
on page 2-9.), slide the ring
Advertisement
Table of Contents
