Table of Contents
Advertisement
Belt Mount Applications
This section describes how to install and mount the belt mount configuration.
Install the Terminal in the Belt Mount Sled
1. If the end cap is installed on the sled, slide the lock down to release the end
cap.
2. Push up on the right side (the side with the lock) of end cap. Do not attempt to remove the end cap
without sliding the lock first!
3. Pull the end cap off the sled.
4. Make sure the USB door is closed. Rotate the door on the right side of the Dolphin 75e to close.
5. Press until the door is flush with the side of the terminal.
Note: If the door is not flush, it may be difficult to remove the terminal from the sled.
2 - 5
Advertisement
Table of Contents
