hit counter script

Operating Display; Warning Display; Fault Display - Bosch Rexroth REFUspeed RS51 Operating Instructions Manual

Drive control devices for high-speed grinding spindles
Table of Contents

Advertisement

REFUspeed RS51
Fault memory
Graphic display
Search for D parameter

Operating display

Warning display

Fault display

DOK-RD500*-RS51*******-IB02-EN-P
LSA Control S.L. www.lsa-control.com comercial@lsa-control.com (+34) 960 62 43 01
Note:
The terms "D parameter" and "Variable parameter source" are
explained in the legend for the function charts, refer to the
documentation "Function charts and parameter list".
The last 10 faults are saved in the fault memory. The youngest fault is in
memory location S0, the oldest in S9. A new fault is always saved at
memory location S0. All of the older faults are shifted upwards by one
position in the memory. This means that the fault at memory location S9
is lost.
The existing V/Hz characteristic is graphically displayed in this menu.
Using "Search for D parameter" a list of "Variable parameter sources" is
displayed in which the selected D parameter is connected. You can scroll
through the list using the Enter key. If the selected D parameter is not
linked to a "Variable parameter source", the following is displayed: "Is not
linked". For a more detailed explanation, refer to the function charts with
legend.
From ten display values, three can be selected for display in the operating
display, refer to P0037.0x in the drive setting.
50.00 Hz
fact
fset
50.00 Hz
operation
Fig. 6-9: Operating display
If a critical operating status occurs, then the warning message and the
operating display are displayed alternating until the critical status has
been resolved.
Warning
Motor overtemp.
Fig. 6-10: Warning display
The fault display replaces the operating display when an operating status
occurs which initiates a fault.
Operator control and visualization
Line 1: Frequency actual value
Line 2: Frequency setpoint
Line 3: Status (operating status)
Active parameter in normal operation.
0
The system changes-over into the
test mode when the
key are simultaneously pressed.
"0T" is then displayed.
50.00 Hz
fact
fset
operation
6-7
and
50.00 Hz
0

Advertisement

Table of Contents
loading

Table of Contents