Deactivate Or Move The Lan Card From Use By Operations Console - IBM E Server i Series Manual
Operations console, access for windows
Hide thumbs
Also See for E Server i Series:
- Manual (86 pages) ,
- Manual (70 pages) ,
- Setting up (70 pages)
Table of Contents
Advertisement
To create a service host name:
1. Access Dedicated Service Tools (DST).
2. Select Work with DST environment.
3. Select System devices.
4. Select Console Mode.
5. Select Operations Console (LAN). This should show Verify Operations Console
6. Press F11 to configure.
7.
For more additional information, see Service tools.
Deactivate or move the LAN card from use by Operations
Console
During a migration you may need to deactivate the LAN card from use by
Operations Console. You should deactivate the LAN card if you are not planning
on using an Operations Console local console on a network configuration. Once
the LAN card is deactivated you can move it and use it for another purpose. You
must also be using a console type other than an Operations Console local console
on a network (LAN) or the steps below will cause the console to disconnect.
Follow these steps to deactivate the LAN adapter currently associated with an
Operations Console local console on a network (LAN):
10. Press F12 to exit this window.
11. Select Console mode.
12. Select the console type you are currently using.
94
iSeries: iSeries Access for Windows Operations Console
Note: You may have to temporarily change the console type to complete this
work. For example, you use twinaxial on the primary partition but want
the remote control panel function for one or more logical partitions.
Adapters.
The service host name field contains the name. If you are creating a new
service connection follow these steps:
a. Enter the network data in the appropriate fields.
b. Store your configuration by pressing the F7 key.
c. Activate the LAN adapter by pressing the F14 key.
d. Exit using F3 or F13.
e. If you had to change the console type from the currently used console to a
Operations Console local console on a network configuration, reselect the
original console type if that choice will remain the console.
1. Access Dedicated Service Tools (DST).
2. Select Work with DST environment.
3. Select System devices.
4.
Select Console mode.
5. Select Operations Console (LAN). The LAN adapter currently in use should
be shown.
6. Press F11.
7. Press F6 to perform a clear.
8. Press F7 to store the new values.
9. If you are not using this resource for the console, press F13 to deactivate the
adapter.You will be required to use another console type or resource on the
next IPL.
You should have returned to the Work with System Devices window.
Advertisement
Table of Contents
