Create Service Tools Device Ids On The Server - IBM E Server i Series Manual
Operations console, access for windows
Hide thumbs
Also See for E Server i Series:
- Manual (86 pages) ,
- Manual (70 pages) ,
- Setting up (70 pages)
Table of Contents
Advertisement
Reset the service tools device ID password on the PC
Reset the service tools device ID password on the PC by doing one of the
following:
v To delete the configuration and re-create it, follow these steps:
v To change or reset the password for the same service tools device ID, follow one
Create service tools device IDs on the server
You need to set up service tools device IDs on the server for a local console on a
network configuration:
1. Access Dedicated Service Tools (DST).
2. Select Work with DST environment.
3. Select Service tools device IDs.
92
iSeries: iSeries Access for Windows Operations Console
1. If connected, disconnect as follows:
a. Select the configuration name (under iSeries Connection). This is the
name that Operations Console uses to refer to a specific system.
b. From the Connection menu, click Disconnect. The connection status
shows Disconnecting .
c. Wait for the status to show Not connected to local console or
Disconnected.
2. Delete the configuration:
a. Select the configuration name (under iSeries Connection) that you want
to delete.
b. From the Connection menu, click Delete.
c. Click Yes to confirm the deletion.
3. Re-create the configuration with the service tools device ID password you
previously reset or with the new service tools device ID.
of these steps:
– To use the connection properties to change or reset the service tools device ID
password, follow these steps:
1. Select the connection name that you will be making the change for, and
then click Connection —> Properties.
2. Select the Device ID tab.
3. Enter the appropriate password in the Passwordand Confirm
passwordfields, and then click OK.
4. The Access Password window will appear. Enter the current access
password, and then click OK.
– To use the configuration wizard to change or reset the service tools device ID
password, follow these steps:
1.
Select the connection name that you will be making the change for, and
then click Connection —> Configure Connection.
2. Accept the values on each window and continue into the wizard until you
get to the Specify Service Device ID window.
3. Enter the appropriate password in the Password and Confirm password
fields, and then click Next.
4. The Access Password window will appear. Enter the current access
password, and then click OK.
5. Continue through the wizard to the last window and click Finish to
rewrite the data and exit the wizard.
Advertisement
Table of Contents
