Husqvarna LC 247i Operator's Manual page 18
Hide thumbs
Also See for LC 247i:
- Operator's manual (748 pages) ,
- Operator's manual (572 pages) ,
- Operator's manual (576 pages)
Table of Contents
Advertisement
Available languages
Available languages
Examine the battery charger for damage and make sure that it operates correct-
ly.
Examine the connections between the battery and the product. Also examine the
connection between the battery and the battery charger.
To do a general inspection
•
Make sure that the nuts and screws on the product
are tightened.
•
Make sure that the cables on the product are not in a
position where they can get damaged.
To clean the product
•
Clean plastic parts with a clean and dry cloth.
•
Do not use water to clean the product. Water can
enter the battery or the motor and cause short circuit
or damage to the product.
•
Do not use a high pressure washer to clean the
product.
•
Do not flush water directly on the motor.
•
Use a brush to remove leaves, grass and dirt.
To clean the battery and the battery
charger
WARNING:
the battery charger with water.
•
Make sure that the battery and the battery charger
are clean and dry before you put the battery into the
battery charger.
•
Clean the battery terminals with compressed air or
use a soft and dry cloth.
•
Clean the surfaces of the battery and the battery
charger with a soft and dry cloth.
To examine the cutting equipment
WARNING:
turn the safety key to 0, remove the battery
and wait a minimum 5 seconds.
WARNING:
when you do maintenance on the cutting
equipment. The blade is very sharp and cuts
can easily occur.
1. Examine the cutting equipment for damage
or cracks. Always replace a damaged cutting
equipment.
2. Look at the blade to see if it is damaged or blunt.
18
Do not clean the battery or
To prevent accidental start,
Use protective gloves
Each use
Note:
It is necessary to balance the blade after it is
sharpened. Let a service center sharpen, replace and
balance the blade. If you hit an obstacle that causes
the product to stop, replace the damaged blade. Let the
service center estimate if the blade can be sharpened or
must be replaced.
To replace the blade
Technical data on page 22 for the correct type
Refer to
of blade.
WARNING:
of wood to prevent injury to fingers when
you replace the blade. The blade can be
moved when the motor is off and fingers
can become trapped between the blade and
stationary parts.
1. Lock the blade with a block of wood.
2. Remove the blade bolt.
3. Remove the blade.
4. Examine the blade support and blade bolt to see if
there are damages.
5. Examine the motor shaft to make sure that it is not
bent.
Each
Monthly
season
X
X
Lock the blade with a block
1696 - 003 - 16.12.2021
- Quick Links:
- Troubleshooting
Hide quick links:
Advertisement
Chapters
Table of Contents
