Installing A Dc-Power-Supply Module - Cisco ME 3400E Hardware Installation Manual

Cisco systems ethernet access switch installation guide

Hide thumbs Also See for Cisco ME 3400E:

Table of Contents

Power-Supply Module Installation

Installing a DC-Power-Supply Module

This procedure is for installing an DC-power-supply module into the PSU 1 power-supply slot. Repeat

these steps to install a power-supply module in the PSU 2 power-supply slot.

To connect the switch to a DC-input power source, follow these steps:

An exposed wire lead from a DC-input power source can conduct harmful levels of electricity. Be sure

Warning

that no exposed portion of the DC-input power source wire extends from the terminal block plug.

Statement 122

Before connecting or disconnecting ground or power wires to the chassis, ensure that power is

Warning

removed from the DC circuit. To ensure that all power is OFF, locate the circuit breaker on the panel

board that services the DC circuit, switch the circuit breaker to the OFF position, and tape the switch

handle of the circuit breaker in the OFF position. Use a voltmeter to test for 0 (zero) voltage at the

power terminals on the chassis. Statement 196

Installation of the equipment must comply with local and national electrical codes.

Caution

The grounding architecture of this product is DC-isolated (DC-I).

Note

We recommend that you use 18 AWG copper wiring for Network Equipment Building Systems (NEBS)

Note

installation. This guideline follows the standard guidelines for DC-power wiring in the central office.

You can use the grounding lug to attach a wrist strap for ESD protection during servicing.

Note

Cisco ME 3400E Ethernet Access Switch Hardware Installation Guide

3-8

Preparing for Installation, page 3-9

Grounding the Switch, page 3-9

Installing the DC-Power-Supply Module in the Switch, page 3-11

Wiring the DC-Input Power Source, page 3-12

Chapter 3

Installing and Removing AC- and DC-Power-Supply Modules

OL-16447-01

Table of Contents